User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 768
6.10.1.22. show bgp ipv6 filter-list
Use this command to display routes that conform to a specified filter list.
Format show bgp ipv6 filter-list <as-path-list>
Default None
Mode Privileged Exec
User Exec
Display Messages
Prefix List Out
The global prefix list used to filter outbound routers from all neighbors.
Networks Originated
The set of networks originated through a network command. Those networks
that are actually advertised to neighbors are marked “active”.
Fields
Definition
as-path-list
Filter the output to the set of routes that match a given AS Path list. It can be a
number from 1 to 500.
Fields
Definition
BGP table version
The BGP Table Version is the main number used. This number is the same as the
Generation ID of any BGP prefix for a specific address family and is used to track
changes to the BGP route table.
Local Route ID
A 32-bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
Status Codes
Status of the table entry. The status is displayed at the beginning of each line in
the table. It can be one of the following values:
• s — The table entry is suppressed.
• * — The table entry is valid.
• > — The table entry is the best entry to use for that network.
• i — The table entry was learned via an internal BGP (iBGP) session.
• S — The table entry stale route.
Origin codes
Origin of the entry. The origin code is placed at the end of each line in the table.
It can be one of the following values:
• i — Entry originated from an Interior Gateway Protocol (IGP) and was
advertised with a network router configuration command.
• e — Entry originated from an Exterior Gateway Protocol (EGP).