User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 763
Default None
Mode Privileged Exec
User Exec
Display Messages
no-export-subconfed
Display only routes that are not sent outside of the local AS or subconfeds.
Fields
Definition
BGP table version
The BGP Table Version is the main number used. This number is the same as the
Generation ID of any BGP prefix for a specific address family and is used to track
changes to the BGP route table.
Local Route ID
A 32-bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
Status Codes
Status of the table entry. The status is displayed at the beginning of each line in
the table. It can be one of the following values:
• s — The table entry is suppressed.
• * — The table entry is valid.
• > — The table entry is the best entry to use for that network.
• i — The table entry was learned via an internal BGP (iBGP) session.
Origin codes
Origin of the entry. The origin code is placed at the end of each line in the table.
It can be one of the following values:
• i — Entry originated from an Interior Gateway Protocol (IGP) and was
advertised with a network router configuration command.
• e — Entry originated from an Exterior Gateway Protocol (EGP).
• ? — Origin of the path is not clear. Usually, this is a router that is
redistributed into BGP from an IGP.
Network
Destination IP address.
Next Hop
IPv6 address of the next system that is used when forwarding a packet to the
destination network.
Metric
The value of the interautonomous system metric. Value of the MED attribute, if
included.
LocPref
Local preference value as set with the set local-preference route-map
configuration command or received from the peer. The default value is 100.
Path
Autonomous system paths to the destination network. There can be one entry in
this field for each autonomous system in the path.