User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 761
User Exec
Display Messages
Fields
Definition
ipv6-prefix/length
The destination IPv6 prefix and prefix length entered to filter the output to
display only a particular host or network in the BGP routing table.
Generation ID
Incremented each time phase 2 of the decision process runs and whenever an
aggregate address changes. Used to track changes to the BGP route table.
Advertised to Update Groups
The outbound update groups that this route is advertised to.
Best Path
Shows best path information as following.
Non-Best Paths
Show non-best path information as following.
Local Preference
Local preference value as set with the set local-preference route-map
configuration command or received from the peer. The default value is 100.
AS Path
An Autnonomous System path is a list of all the autonomous systems that a
specific route passes through to reach one destination.
Origin
Indicates the origin of the entry. It can be IGP, EGP, and Incomplete. Value of the
ORIGIN attribute.
Metric
The value of the interautonomous system metric. Value of the MED attribute, if
included.
Type
Type of peer (internal or external).
IGP Cost
The cost of Interior Gateway Protocol (IGP) to the BGP NEXT HOP.
Peer (Peer ID)
The IP Address of the Peer's BGP interface (The Router ID of the Peer's BGP).
BGP Next Hop
IP address of the next system that is used when forwarding a packet to the
destination network.
Atomic Aggregate
Include atomic-aggregate routes or not.
Aggregator (AS, Router ID)
The information (AS number and router ID) of the speaker that aggregated the
routes.
Communities
Valid value is a BGP community number in the range from 1 to 4294967200, or
AA:NN (autonomous system-community number/2-byte number), no-peer, no-
export, no-export-subconfed, or no-advertise.
Originator
The value of the ORIGINATOR attribute, if the attribute is attached to the path.
Cluster list
The value of the CLUSTER LIST attribute, if the attribute is attached to the path.