User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 747
6.10.1.5. show ip bgp community-list
This command display routes that are permitted by the Border Gateway Protocol (BGP) community list.
Format show ip bgp community-list <community-list-name> [exact-match]
Local Route ID
A 32-bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
Status Codes
Status of the table entry. The status is displayed at the beginning of each line in
the table. It can be one of the following values:
• s — The table entry is suppressed.
• * — The table entry is valid.
• > — The table entry is the best entry to use for that network.
• i — The table entry was learned via an internal BGP (iBGP) session.
Origin codes
Origin of the entry. The origin code is placed at the end of each line in the table.
It can be one of the following values:
• i — Entry originated from an Interior Gateway Protocol (IGP) and was
advertised with a network router configuration command.
• e — Entry originated from an Exterior Gateway Protocol (EGP).
• ? — Origin of the path is not clear. Usually, this is a router that is
redistributed into BGP from an IGP.
Network
Destination IP address.
Next Hop
IP address of the next system that is used when forwarding a packet to the
destination network. An entry of 0.0.0.0 indicates that the router has some non-
BGP routes to this network.
Metric
The value of the interautonomous system metric. Value of the MED attribute, if
included.
LocPref
Local preference value as set with the set local-preference route-map
configuration command or received from the peer. The default value is 100.
Path
Autonomous system paths to the destination network. There can be one entry in
this field for each autonomous system in the path.
Fields
Definition
community-list-name
Community list name. The community list name can be standard or expanded.