User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 700
6.3.2.39. ip ospf cost
ip ospf cost command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to
65535. no ip ospf cost command configures the default cost on an OSPF interface.
Format ip ospf cost <1–65535>
no ip ospf cost
Default 10
Mode Interface Config
6.3.2.40. ip ospf dead-interval
ip ospf dead-interval command sets the OSPF dead interval for the specified interface. The value for <seconds>
is a valid positive integer, which represents the length of time in seconds that a router's Hello packets have not
been seen before its neighbor routers declare that the router is down. The value for the length of time must be
the same for all routers attached to a common network. This value should be some multiple of the Hello Interval
(i.e. 4). Valid values range in seconds from 1 to 65535. no ip ospf dead-interval command sets the default OSPF
dead interval for the specified interface.
Format ip ospf dead-interval <seconds>
no ip ospf dead-interval
Default 40
Mode Interface Config
6.3.2.41. ip ospf hello-interval
ip ospf hello-interval command sets the OSPF hello interval for the specified interface. The value for seconds is a
valid positive integer, which represents the length of time in seconds. The value for the length of time must be
the same for all routers attached to a network. Valid values range from 1 to 65535. no ip ospf hello-interval
command sets the default OSPF hello interval for the specified interface.
Format ip ospf hello-interval <seconds>
no ip ospf hello-interval
Default 10
Mode Interface Config
6.3.2.42. ip ospf network
ip ospf network command to configure OSPF to treat an interface as a point-to-point rather than broadcast
interface. The broadcast option sets the OSPF network type to broadcast. The point-to-point option sets the
OSPF network type to point-to-point. OSPF treats interfaces as broadcast interfaces by default. (Loopback