User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 653
6.2.1.12. show ip route ecmp-groups
This command displays all the current ECMP groups in the IPv4 routing table. An ECMP group is a set of two or
more next hops used in one or more routes. The groups are numbered arbitrarily from 1 to n. The output
indicates the number of next hops in the group and the number of routes that use the set of the next hops.The
output lists the IPv4 address and the outgoing interface of each next hop in each group.
Format show ip route [vrf <vrf-name>] ecmp-groups
Default None
Mode Privileged EXEC
6.2.1.13. show ip route hw-failure
This command displays the routes that failed to be added to the hardware due to the hash errors or a table full
condition.
Format show ip route hw-failure
Default None
Mode Privileged EXEC
Display Message
Fields
Definition
Code
The codes for the routing protocols that created the routes.
IP-Address/Mask
The IP-Address and mask of the destination network corresponding to this route.
Preference
The administrative distance associated with this route. Routes with low values
are preferred over routes with higher values.
Metric
The cost associated with this route.
via Next-Hop
The outgoing router IP address to use when forwarding traffic to the next router
(if any) in the path toward the destination.
Interface
The outgoing router interface to use when forwarding traffic to the next
destination.
Fields
Definition
Route Codes
Displays the key for the routing protocol codes that might appear in the routing
table output.