User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 634
5.33. Precision Time Protocol Transparant Clock Commands
The switch supports Precision Time Protocol (PTP) Transparant Clock (TC).
5.33.1. ptp clock e2e-transparent
Use this command to enable the PTP E2E transparent clock at system level (that is, globaly) or for an interface.
In Global Config mode, the command applies the PTP transparent clock configuration to all physical ports and
LAGs on the switch. In Interface Config mode, the command provides a next-level control so that you can disable
this feature selectively for an individual physical port or LAG.
You can configure the PTP transparent clock for physical ports and LAGs, but not for another type of interface,
such as a VLAN, loopback, or tunnel. If you configure the PTP transparent clock on a LAG, the configuration is
applied to all member ports. For example, if a member port is enabled and the LAG is disabled, the operational
mode of that member is disabled because the LAG configuration takes precedence over the administrative
mode of the member port.
To disable the PTP E2E transparent clock at system level or for an interface, use the no form of this command.
Format ptp clock e2e-transparent
no ptp clock e2e-transparent
Default Enabled at system level and for all interfaces
Mode Global Config
Interface Config
5.33.2. show ptp clock e2e-transparent
Use this command to display the operational and configuration status of the PTP E2E transparent clock, both at
system level and at interface level.
Format show ptp clock e2e-transparent
Mode Privileged Exec
Display Message
Fields
Definition
Interface
The interface on which the feature is configured.
Configured Mode
The configuration status of the PTP E2E transparent clock on the interface.
Operational Mode
The operational status of the PTP E2E transparent clock on the interface.