User Manual

Table Of Contents

NETGEAR M4500 Series Switches CLI Command Reference Manual 451

5.15.23. lldp timers

This command is used to set the timing parameters for local data transmission on ports enabled for LLDP. The

<interval-seconds> determines the number of seconds to wait between transmitting local data LLDPDUs. The

range is 5-32768 seconds. The <hold-value> is the multiplier on the transmit interval that sets the TTL in local

data LLDPDUs. The multiplier range is 2-10. The <reinit-seconds> is the delay before re-initialization, and the

range is 1-10 seconds.

Format lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-seconds>]

Default Interval-seconds 30

Hold-value 4

Reinit-seconds 2

Mode Global Config

5.15.24. no lldp timers

This command is used to return any or all timing parameters for local data transmission on ports enabled for

LLDP to the default values.

Format no lldp timers [interval] [hold] [reinit]

Mode Global Config

5.15.25. lldp tx-delay

This command is used to set the timing parameters for data transmission delay on ports enabled for LLDP. The

<delay-seconds> determines the number of seconds to wait between transmitting local data LLDPDUs. The

range is 1-8192 seconds.

Format lldp tx-delay <delay-seconds>

Default 2

Mode Global Config

5.15.26. no lldp tx-delay

This command is used to return the transmit delay to the default value.

Format no lldp tx-delay

Mode Global Config