User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 399
5.11. AAA Commands
This section describes the commands you use to add, manage, and delete system users. Software has two
default users: admin and guest. The admin user can view and configure system settings, and the guest user can
view settings.
Note: You cannot delete the admin user. There is only one user allowed with read/write privileges. You can
configure up to five read-only users on the system.
5.11.1. show accounting
This command displays ordered methods for accounting lists.
Format show accounting
Mode Privileged EXEC
User EXEC
Example: The following shows example CLI display output for this command.
(M4500-32C) #show accounting
Number of Accounting Notifications sent at beginning of an EXEC session: 0
Errors when sending Accounting Notifications beginning of an EXEC session: 0
Number of Accounting Notifications sent at end of an EXEC session: 0
Errors when sending Accounting Notifications at end of an EXEC session: 0
Number of Accounting Notifications sent at beginning of a command execution: 0
Errors when sending Accounting Notifications at beginning of a command execution: 0
Number of Accounting Notifications sent at end of a command execution: 0
Errors when sending Accounting Notifications at end of a command execution: 0
5.11.2. show accounting methods
This command displays configured accounting method lists.
Format show accounting methods
Mode Privileged EXEC
User EXEC
Example: The following shows example CLI display output for this command.