User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 339
the path cost as a number in the range of 1 to 200000000 or auto. If you select auto the path cost value is set
based on Link Speed.
If you specify the port-priority option, this command sets the priority for this port within a specific multiple
spanning tree instance or the common and internal spanning tree instance, depending on the mstid parameter.
The port-priority value is a number in the range of 0 to 240 in increments of 16.
Note: If the MST is enabled with MLAG, the path cost of the MLAG peer-link cannot be modified.
Format spanning-tree mst <mstid> {{cost <1-200000000> | auto} | port-priority <0-240>}
Default cost: auto
port-priority: 128
Mode Interface Config
5.5.37. no spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree instance, or in
the common and internal spanning tree to the respective default values. If you specify an mstid parameter that
corresponds to an existing multiple spanning tree instance, you are configuring that multiple spanning tree
instance. If you specify 0 (defined as the default CIST ID) as the mstid, you are configuring the common and
internal spanning tree instance.
If you specify cost, this command sets the path cost for this port within a multiple spanning tree instance or the
common and internal spanning tree instance, depending on the mstid parameter, to the default value, i.e., a
path cost value based on the Link Speed.
If you specify port-priority, this command sets the priority for this port within a specific multiple spanning tree
instance or the common and internal spanning tree instance, depending on the mstid parameter, to the default
value.
Format no spanning-tree mst <mstid> {cost | port-priority}
Mode Interface Config
5.5.38. spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Format spanning-tree port mode
Default Enabled
Mode Interface Config