User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 280
5.4.10.4. show sflow samplers
The user can go to the CLI Privilege Exec to get the sFlow sampling instances created on the switch, use the
show sflow samplers Privilege command.
Format show sflow samplers
Default None
Mode Privilege Exec
Display Message
Receiver Index
The sFlow Receiver associated with the sampler/poller.
Owner String
The identity string for receiver, the entity making use of this sFlowRcvrTable
entry.
Time Out
The time (in seconds) remaining before the receiver is released and stops sending
samples to sFlow receiver. The no timeout value of this parameter means that
the sFlow receiver is configured as a non-timeout entry.
Max Datagram Size
The maximum number of bytes that can be sent in a single sFlow datagram.
Port
The destination Layer4 UDP port for sFlow datagrams.
IP Address
The sFlow receiver IP address.
Address Type
The sFlow receiver IP address type. For an IPv4 address, the value is 1.
Datagram Version
The sFlow protocol version to be used while sending samples to sFlow receiver.
Parameter
Definition
Sampler Data Source
The sFlowDataSrouce for this sFlow sampler. This agent supports physical ports
only.
Receiver Index
The sFlowReceiver configured for this sFlow sampler.
Remote Agent
The remote agent instance index number.
Ingress Sampling Rate
The sampling rate for the ingress.
Flow Sampling Rate
The statistical sampling rate for packet sampling from this source.
Egress Sampling Rate
The sampling rate for the egress.
Max Header Size
The maximum number of bytes that should be copied from a sampled packet to
form a flow sample.