User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 248
The SNMP agent of the switch complies with SNMP versions 1, 2c, and 3 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external SNMP manager
based on the SNMP configuration (the trap receiver and other SNMP community parameters).
Note: By default, no community strings such as ‘private’ or ‘public’ exist for SNMPv1 and SNMPv2. In addition,
the MD5 authentication procotol is used for SNMPv3, and the ‘None’ authentication protocol is not
allowed.
Format show snmp
Default None
Mode Privileged EXEC
Display Message
Parameter
Definition
Community-String
The community string to which this entry grants access. A valid entry is a case-
sensitive alphanumeric string of up to 20 characters. Each row of this table must
contain a unique community name.
Community-Access
The access level for this community string.
View Name
The view this community has access to.
IP Address
Access to this community is limited to this IP address.
Group Name
The community this mapping configures.
Target Address
An IP address (or portion thereof) from which this device will accept SNMP
packets with the associated community.
Type
The type of message that will be sent, either traps or informs.
Community
The community traps will be sent to.
Version
The version of SNMP the trap will be sent as.
SNMP v1
Uses SNMP v1 to send traps to the receiver.
SNMP v2
Uses SNMP v2 to send traps to the receiver.
SNMP v3
Uses SNMP v3 to send traps to the receiver.
UDP Port
The UDP port the trap or inform will be sent to.
Filter name
The filter the traps will be limited by for this host.
TO Sec
The number of seconds before informs will time out when sending to this host.
Retries
The number of times informs will be sent after timing out.