User Manual
Table Of Contents
- Contents
- 1. Hardware Setup
- 2. Connect to the Network and Access the Cable Modem Router
- 3. Specify Your Internet Settings
- 4. Control Access to the Internet
- 5. Specify Network Settings
- View or Change WAN Settings
- Dynamic DNS
- Set Up a Default DMZ Server
- Change the Router’s Device Name
- Change the LAN TCP/IP Settings
- Use the Router as a DHCP Server
- Disable the DHCP Server Feature in the Router
- Manage Reserved LAN IP Addresses
- Custom Static Routes
- Specify Basic WiFi Settings
- Set Up a Guest WiFi Network
- View or Change Advanced WiFi Settings
- Enable Router Mode
- Generate a New Backhaul Password
- Check Your Internet Bandwidth
- Improve Network Connections With Universal Plug N Play
- 6. Manage Your Network
- Update the Router and Satellite Firmware
- Change the admin Password
- Set Up Password Recovery
- Recover the admin Password
- View Router Status
- View Satellite Status
- View and Manage Logs of Router Activity
- View Devices Connected to the Network
- View Satellites Connected to the Network
- Monitor Internet Traffic
- Manage the Router Configuration File
- Set Up Remote Management
- Use Remote Access
- Remotely Access Your Router Using the NETGEAR Orbi App
- 7. Customize Internet Traffic Rules for Ports
- 8. Use VPN to Access Your Network
- 9. Troubleshooting
- 10. Supplemental Information
Factory Settings
You can return the cable modem router and satellite to its factory settings. Use the end of a paper clip or a
similar object to press and hold the Reset button on the back of the cable modem router or satellite for at
least seven seconds.The cable modem router or satellite resets, and returns to the factory settings.
Factory Settings for Orbi Cable Modem Router
The following table shows the factory default settings for the cable modem router.
Table 5. Factory default settings for the cable modem router
Default SettingFeature
orbilogin.comUser login URLRouter
login
adminUser name (case-sensitive)
passwordLogin password (case-sensitive)
Use default hardware addressWAN MAC addressInternet
connection
1500WAN MTU size
AutoSensingPort speed
192.168.1.1LAN IPLocal
network
(LAN)
255.255.255.0Subnet mask
EnabledDHCP server
192.168.1.2 to 192.168.1.254DHCP range
192.168.1.2DHCP starting IP address
192.168.1.254DHCP ending IP address
DisabledDMZ
GMT for WW except NA and GR, GMT+1
for GR, GMT-8 for NA
Time zone
DisabledTime zone adjusted for daylight saving
time
DisabledSNMP
Disabled (except traffic on port 80, the
HTTP port)
Inbound (communications coming in from
the Internet)
Firewall
Enabled (all)Outbound (communications going out to
the Internet)
DisabledSource MAC filtering
Supplemental Information
97
Orbi WiFi System