Use and Care Manual
Table Of Contents
- Contents
- 1. Hardware Setup
- 2. Specify Your Internet Settings
- 3. Connect to the Network and Access the Modem Router
- 4. Control Access to the Internet
- 5. Manage Network Settings
- View or change the WAN settings
- Set up a default DMZ server
- Change the Router’s Device Name
- Change the LAN TCP/IP settings
- Specify the IP addresses that the modem router assigns
- Disable the DHCP server feature in the modem router
- Manage reserved LAN IP addresses
- Use the WPS Wizard for WiFi connections
- Specify Basic WiFi Settings
- Change the WiFi Mode
- Change the Transmission Power Control
- Change the WiFi password or the WiFi security
- Set up a guest WiFi network
- Control the WiFi radios
- Set up a WiFi schedule
- Specify WPS settings
- Enable or disable implicit beamforming
- Enable or disable airtime fairness
- Ethernet Port Aggregation
- 6. Manage Your Modem Router
- Update the router firmware
- Change the admin password
- Enable admin password recovery
- Recover the admin password
- View information about the router and the Internet and WiFi settings
- Display the statistics of the Internet port
- Check the Internet connection status
- View and manage logs of router activity
- View devices currently on the network
- View event logs
- Monitor Internet traffic
- Manage the router configuration file
- Remotely access your router using the Nighthawk app
- Disable LED blinking or turn off LEDs
- Set your time zone
- Set the NTP Server
- Specify ReadyDLNA media server settings
- Return the router to its factory default settings
- 7. Share USB Storage Devices Attached to the Modem Router
- USB device requirements
- Connect a USB storage device to the router
- Access a storage device connected to the router from a Windows-based computer
- Map a USB device to a Windows network drive
- Access a storage device that is connected to the router from a Mac
- Enable FTP access within your network
- View network folders on a storage device
- Add a network folder on a USB storage device
- Edit a network folder on a USB storage device
- Safely remove a USB storage device
- 8. Use Dynamic DNS to Access USB Storage Devices Through the Internet
- 9. Use VPN to Access Your Network
- 10. Manage Port Forwarding and Port Triggering
- 11. Troubleshooting
- 12. Supplemental Information
Table 3. Cable Internet provider contact information (Continued)
Contact InformationCable Internet Provider
https://www.spectrum.net/contact-us/https://activate.spectrum.net/
1-833-267-6094
Spectrum
https://www.xfinity.com/internetsetup
1-800-XFINITY (1-800-934-6489)
Use the Xfinity app for Xfinity activation and then use the NETGEAR
Nighthawk app for router installation.
Xfinity
®
Note: Your cable Internet provider’s contact information might change. You can find
the contact information in your monthly Internet service billing statement.
To activate your Internet service:
1.
Visit your cable Internet provider’s website and follow the onscreen instructions to
activate your Internet service.
2.
If you are unable to activate your Internet service using the instructions on your cable
Internet provider’s website, call your cable Internet provider for support.
3. To determine the accurate Internet speed, visit your cable Internet provider's speed
test website and perform a speed test. .
If your actual speed is lower than your subscribed speed, contact your cable Internet
provider.
Perform a Speed Test
To determine the accurate Internet speed, visit your cable Internet provider's speed
test website and perform a speed test.
If your actual speed is lower than your subscribed speed, contact your cable Internet
provider.
User Manual17Hardware Setup
Nighthawk AX6 AX2700 WiFI Cable Modem Router Model CAX30