Use and Care Manual
Table Of Contents
- Contents
- 1. Hardware Setup
- 2. Specify Your Internet Settings
- 3. Connect to the Network and Access the Modem Router
- 4. Control Access to the Internet
- 5. Manage Network Settings
- View or change the WAN settings
- Set up a default DMZ server
- Change the Router’s Device Name
- Change the LAN TCP/IP settings
- Specify the IP addresses that the modem router assigns
- Disable the DHCP server feature in the modem router
- Manage reserved LAN IP addresses
- Use the WPS Wizard for WiFi connections
- Specify Basic WiFi Settings
- Change the WiFi Mode
- Change the Transmission Power Control
- Change the WiFi password or the WiFi security
- Set up a guest WiFi network
- Control the WiFi radios
- Set up a WiFi schedule
- Specify WPS settings
- Enable or disable implicit beamforming
- Enable or disable airtime fairness
- Ethernet Port Aggregation
- 6. Manage Your Modem Router
- Update the router firmware
- Change the admin password
- Enable admin password recovery
- Recover the admin password
- View information about the router and the Internet and WiFi settings
- Display the statistics of the Internet port
- Check the Internet connection status
- View and manage logs of router activity
- View devices currently on the network
- View event logs
- Monitor Internet traffic
- Manage the router configuration file
- Remotely access your router using the Nighthawk app
- Disable LED blinking or turn off LEDs
- Set your time zone
- Set the NTP Server
- Specify ReadyDLNA media server settings
- Return the router to its factory default settings
- 7. Share USB Storage Devices Attached to the Modem Router
- USB device requirements
- Connect a USB storage device to the router
- Access a storage device connected to the router from a Windows-based computer
- Map a USB device to a Windows network drive
- Access a storage device that is connected to the router from a Mac
- Enable FTP access within your network
- View network folders on a storage device
- Add a network folder on a USB storage device
- Edit a network folder on a USB storage device
- Safely remove a USB storage device
- 8. Use Dynamic DNS to Access USB Storage Devices Through the Internet
- 9. Use VPN to Access Your Network
- 10. Manage Port Forwarding and Port Triggering
- 11. Troubleshooting
- 12. Supplemental Information
Table 1. LED descriptions (Continued)
•
Solid white. The 2.4 GHz WiFi radio is operating.
•
Blinking. The router is sending or receiving WiFi traffic.
•
Off. The 2.4 GHz WiFi radio is off.
2.4 GHz radio
•
Solid white. The 5 GHz WiFi radio is operating.
•
Blinking. The router is sending or receiving WiFi traffic.
•
Off. The 5 GHz WiFi radio is off.
5 GHz radio
•
Solid white. A USB device is connected and is ready.
•
Off. No USB device is connected, or someone clicked the Safely
Remove Hardware button and it is now safe to remove the attached
USB device.
USB port
The WiFi and WPS buttons are located on the front of the modem router.
Table 2. Front panel buttons
DescriptionButton
Pressing this button for two seconds turns the WiFi radios in the modem
router on and off. If this LED is lit, the WiFi radios are on. If this LED is off,
the WiFi radios are turned off and you cannot use WiFi to connect to the
modem router.
WiFi
This button lets you use WPS to join the WiFi network without typing the
WiFi password. The WPS LED blinks during this process and then lights
solid.
WPS
Pressing this button for two seconds turns the LEDs on and off.LED on/off
Rear Panel
The connections and button on the rear panel are shown in the following figure.
User Manual12Hardware Setup
Nighthawk AX6 AX2700 WiFI Cable Modem Router Model CAX30