User Manual
Table Of Contents
- Contents
- 1. Hardware Setup
- 2. Connect to the Network and Access the Cable Modem Router
- 3. Specify Your Internet Settings
- 4. Control Access to the Internet
- 5. Share USB Devices Attached to the Cable Modem Router
- USB Storage Device Requirements
- Connect a USB Storage Device to the Cable Modem Router
- Access a USB Device Connected to the Cable Modem Router From a Windows-Based Computer
- Map a USB Device to a Windows Network Drive
- Access a USB Storage Device That Is Connected to the Cable Modem Router From a Mac
- Control Access to the USB Storage Device
- Use FTP Within the Network
- View or Change Network Folders on a USB Storage Device
- Add a Network Folder on a USB Storage Device
- Edit a Network Folder on a USB Storage Device
- Approve USB Devices
- Access the USB Storage Device Through the Internet
- Safely Remove a USB Storage Device
- 6. Share a USB Printer
- 7. Specify Network Settings
- View or Change the WAN Settings
- Set Up a Default DMZ Server
- Change the Cable Modem Router’s Device Name
- Change the LAN TCP/IP Settings
- Specify the IP Addresses That the Cable Modem Router Assigns
- Disable the DHCP Server Feature in the Cable Modem Router
- Manage LAN IP Addresses
- Improve Network Connections With Universal Plug-N-Play
- Use the WPS Wizard for WiFi Connections
- Specify Basic WiFi Settings
- Change the WiFi Security Option
- Set Up a Guest Network
- Control the WiFi Radios
- Specify WPS Settings
- Enable or Disable Router Mode
- 8. Manage Your Network
- Change the admin Password
- Set Up Password Recovery
- Recover the admin Password
- View Modem Router Status
- View Logs of Cable Modem Router Activity
- View Event Logs
- Run the Ping Utility
- Run the Traceroute Utility
- Monitor Internet Traffic
- View Devices Currently on the Network
- Manage the Cable Modem Router Configuration File
- View or Change the Cable Modem Router WiFi Channel
- Set Up and Manage Dynamic DNS
- Remote Management
- 9. Specify Internet Port Settings
- 10. Troubleshooting
- 11. Supplemental Information
Factory Settings
You can return the cable modem to its factory settings. Use the end of a paper clip or
a similar object to press and hold the Reset button on the back of the cable modem
for at least seven seconds. The cable modem resets, and returns to the factory
configuration settings shown in the following table.
Table 4. Factory default settings
Default behaviorFeature
www.routerlogin.net or 192.168.0.1User login URLCable
modem
router
login
adminUser name (case-sensitive)
The first time that you log in to the modem
router, you are prompted to set the admin
password
Login password (case-sensitive)
192.168.0.1LAN IPLocal
network
(LAN)
255.255.255.0Subnet mask
EnabledDHCP server
192.168.0.2 to 192.168.0.254DHCP range
DisabledDMZ
ISP/MSO ToD (time of day) configurationTime zone
EnabledSNMP
DisabledInbound (communications coming in
from the Internet)
Cable
modem
firewall
Enabled (all)Outbound (communications going out
to the Internet)
User Manual107Supplemental Information
AC1750 WiFi Cable Modem Router