Quick Start Manual

May 2010

NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or

registered trademarks of their respective holders. Information is subject to change without notice

Technical Support

Thank you for selecting NETGEAR products.

After installing your device, locate the serial number on the label of your product and

use it to register your product at http://www.NETGEAR.com/register. Registration is

required before you can use our telephone support service. Registration via our web

site is strongly recommended.

Go to http://kbserver.netgear.com for product updates and Web support. For Warranty

and Regional Customer Support information, see the Warranty Card that came with

your product.

Regulatory Compliance

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability,

NETGEAR reserves the right to change the product described in this document without

notice. NETGEAR does not assume any liability that may accrue due to the use or

application of the product(s) or circuit layout(s) described herein.

Certificate of Manufacture/Importer

It is hereby certified the NETGEAR model AXM763 has been suppressed in

accordance with the condition set out in MBPT-Amtsb|Vfg 243/1991 and vfg 46/

1992. The operation of some equipment (for example, test transmitters) in accordance

with regulation may, however, be subject to certain restrictions. Please refer to the note

in the operating instructions. Federal Office for Telecommunications Approvals has

been notified of the placing of this equipment on the market and has been granted the

right to test the series for compliance with regulation.

Note: This device has been tested and found to comply with limits for a Class B digital

device, pursuant to part 15 of FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a commercial installation.

Laser Safety Warning

This is a Class 1 laser product.

Warning: Because invisible laser radiation may be emitted from aperture of the port

when no fiber cable is connected, avoid exposure to laser radiation and do

not stare into the open aperture.