Installation Guide

AirCard 800 Series Installation Guide
20 2130893
2. Installing the 3G Watcher software
Note: Users of Windows 2000
must be logged in with adminis-
trative privileges. Users of
Windows XP may require admin-
istrative privileges.
Note: If you are running Windows 2000, Windows Installer Redistrib-
utable 2.0 must be installed. This is available on the Microsoft web
site, www.microsoft.com.
Note: You may require your Windows CD.
Note: If you are running
Mac OS X, please refer to the
Watcher Quick Start Guide for
the Mac OS X 10.4.x found at
www.sierrawireless.com/mac
1. IfyourpackagedoesnotincludeaninstallationCD,
proceedto“4.TRU‐Install”onpage 21.
2. InserttheinstallationCDintoyourCD‐ROMdrive.The
CDshouldAutoRunanddisplayamenu.
IftheCDdoesnotAutoRun,select
Start > Runandenter
d:\setup.exewheredisthedriveletterofyourCD‐ROM
drive.
3. FromtheCDstart‐upmenu,selectyourlanguage,then
installation,andthenclickthelinkundersoftware installation
tolaunchtheinstaller.
4. Usethe
NextandBackbuttonstonavigatethroughthe
installer.
5. ToclosetheCDstart‐upmenu,clickthe
exit optioninthe
lowerrightcornerofthewindow.
3. Inserting the AirCard modem
Without the ExpressCard to PC Card adapter
1. Withthelabelfacingup,inserttheAirCardmodeminto 
yourPC Card/ExpressCardslot.
Note: Do not forcefully insert the
AirCard modem. This may
damage connector pins. If you
have more than one
PC Card/ExpressCard slot, you
may obtain better signal strength
using the top slot.
Figure 2-5: Inserting the AirCard 875/88x modem