User Guide

Clear Spot 4G+ User Guide
92 2131352
3G Panel
1. Log in to the home page.
2. Click
Advanced settings ().
3. Click
WAN > 3G.
From this window, you can view or update this information, or perform these
actions:
•
Connection Status: connected, not connected, or dormant.
Dormant means a connection is established, but no data is being transferred.
•
Service Type used for the data connection (1xRTT, EVDO, or EVDO Rev. A).
•
Coverage Type available, and RSSI and Ec/Io for each type.
RSSI reflects the signal strength of the network.
Ec/Io is a dimensionless ratio of the average power of a channel, typically the
pilot channel, to the total signal power.
•
MDN (Mobile Directory Number) — a 10-digit phone number.
•
SID (System ID)
The System ID identifies your home network area.
•
MSID (Mobile Station ID)
The MSID is also known as IMSI (International Mobile Station Identity) — an
identifier of a device on the 3G network.
•
NAI (Network Access Identifier)
The NAI is a user ID for accessing the 3G network.
•
PRL Version
The PRL (Preferred Roaming List) is an account configuration item set by
your service provider. It controls the radio channels and network carrier used
by the 3G modem. An updated PRL may improve your 3G network service.
•
Load 3G PRL — For example, you've received via email or downloaded a file).
Alternatively, you can check online for a PRL update — in
Advanced settings
> WAN > Setup
, click Update 3G PRL.
Resetting the 3G/4G Configuration to Default Settings
Note: Reset the configuration only if instructed by a CLEAR representative.
After a configuration reset:
• You must go through the device setup (
page 37) and 3G activation (the latter starts
automatically).
• Any changes you've made to the settings are lost.
1. Log in to the home page.
2. Click
Advanced settings ().
3. Click
Device > About.
4. Click
Reset Device to Factory Defaults.