User's Manual

The following paragraphs apply to WN2500RP:
This device is a 2.4GHz and 5GHz wideband transmission system (transceiver), intended for indoor use only in all EU
member states, EFTA states, and Switzerland.
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to
use the device for setting up outdoor radio links and/or for applying public access to telecommunications and/or
network services.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may
be limited to 10mW EIRP in the frequency range of 2454-2483.5 MHz. For detailed information the end-user should
contact the national spectrum authority in France.
The following paragraph applies to the LG2210:
External antenna requirement: Net gain (antenna + cable) of external antenna is required to be less than 1.14dBi
(minimum gain of internal antenna).
Warning
NETGEAR Class A products that may be utilized in domestic/residential environments may cause radio interference
in which case the user may be required to take adequate measures.
FCC Requirements for Operation in the United States
Information in this section applies to products bearing the FCC mark (or statement):
FCC Information to User
This NETGEAR product does not contain any user serviceable components and is to be used with approved
antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and
approvals.
Devices authorized under the DoC procedure must also include a compliance information statement (in the user
manual or on a separate sheet) as required by Section 2.1077. The objective of this compliance statement is to allow
the FCC to associate the equipment with the party responsible for compliance with the identification, by name,
address and telephone number, of the responsible party, as defined in Section 2.909. The responsible party for a
Declaration of Conformity must be located within the United States.
The following statement applies to these products:
 C6300
 FS305v2
 R6200v3
 WNDA3100v3
 C7000BMX
 FS308v2
 R6220
 WNDR3400v3
 D3600
 FS605v4
 R7500
 WNDR3700v5
 D3610
 FS608v4
 R8000
 WNDR4300v2
 D6000
 GS205v2
 STS7000
 WNDR4500v3
 D6010
 GS208v2
 VEGN2200
 WNR2010
 D6200V2
 GS305
 VMB3000
 WNR2020
 D7000
 GS308v2
 VMC3010
 WNR614
 EX2700
 GS605v5
 VMC3030
 WNR618
 EX3700
 GS608v4
 WN370
 EX6100
 HMNC100
 WN1000v4
 EX6150
 JNR1010v2
 WN2500RP