User manual

Advanced Settings
92
AirCard 810 Mobile Hotspot
3. Enter the administrator login password.
The default password is password.
The password is case-sensitive.
The home screen displays.
4. Select Settings > Network >
APN.
5. Click the Add button.
6. Enter the name of the network service provider and the
APN that you obtained from it.
7. Enter the user name and password, if they are required for the WiFi network.
8. Select the network authentication mode:
• None.
The service provider does not require authentication. This is the default
setting.
• PA
P. The service provider uses Password Authentication Protocol (PAP).
• CHAP.
The service provider uses Challenge Handshake Authentication Protocol
(CHAP).
• P
AP or CHAP. The service provider uses either PAP or CHAP.
9. Change the PDP (data protocol), if necessary:
• IPV4.
The mobile broadband network uses IPv4 only. This is the default setting.
• IPV6.
The mobile broadband network uses IPv6 only.
• IPV4V6.
The mobile broadband network uses either IPv4 or IPv6.
10. Change the PDP roaming protocol, if necessary:
• None.
The mobile hotspot does not use the specified PDP for roaming. This is the
default setting.
• IPV4.
The mobile broadband network uses IPv4 only for roaming.
• IPV6.
The mobile broadband network uses IPv6 only for roaming.
• IPV4V6.
The mobile broadband network uses either IPv6 or IPv6 for roaming.
Note: PDP roaming protocol is the IP protocol used while you are roaming
(for example when you are traveling and the roaming network does
not support IPv6).