User Manual

EX6200
VEGN2200
WNDA3100v3
HMNC100
VMB3000
WNDR3400v3
The device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
The following statement applies to these products:
A6210
EX6100
STS7000
C6300
EX6200
WN2500RP
C6300XB3
HMNC100
WNDR3400v3
C7000BMX
JR6150
WNDR3700v5
D6000
R6050
WNDR4300v2
D6010
R6200v3
WNDR4500v3
D3600
R6220
D3610
R7500
D6200V2
R8000
The device operates in 5.15~5.25GHz frequency range. It is restricted in indoor environment only.
The following statements apply to this product:
WAC120
WNDR3400v3
The device operates in 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range. It is restricted in indoor environment only.
The band from 5600-5650MHz will be disabled by the software during the manufacturing and cannot be changed by
the end user. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Non-DFS Warning
NETGEAR non-DFS products do not support operation in the 5600-5650MHz band. The firmware on the device
restricts the operation in this frequency band and does not utilize the channels in this band.
NETGEAR non-DFS products will not permit operations on channels 120132 for 11a and 11n/a, which overlap the
56005650MHz band.
The following statements apply to these products:
A6210
HMNC100
R7500
R8000
WNDR3400v3
NETGEAR DFS products do not support operation in the 5600-5650MHz band. The firmware on the device restricts
the operation in this frequency band and does not utilize the channels in this band.
NETGEAR DFS products will not permit operations on channels 120132 for 11a and 11n/a, which overlap the 5600
5650MHz band.
Country Code Selection Usage (WLAN devices)
The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all
WiFi product marketed in US must fixed to US operation channels only.