Installation Guide

Installation options
Insight Managed WiFi 6 AX1800
Dual Band Access Point
Model WAX610
Bracket for ceiling mounting
Package contents
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
© NETGEAR, Inc., NETGEAR and the NETGEAR
Logo are trademarks of NETGEAR, Inc. Any
non‑NETGEAR trademarks are used for reference
purposes only.
May 2020
NETGEAR INTERNATIONAL LTD
Floor 1, Building 3,
University Technology Centre
Curraheen Road, Cork,
T12EF21, Ireland
Insight Managed
WiFi 6 AX1800
Dual Band Access Point
Model WAX610
Installation Guide
2. Line up the holes on the bottom of the
access point with the screws in the wall and
mount the access point to the wall.
Mount to a ceiling
You can mount the access point to a wall or
ceiling, or you can install it freestanding on a
at surface.
We recommend that you use a at Ethernet
cable so that the cable ts in the narrow
space between the access point and the
surface on which it is mounted or placed.
Mount to a wall
1. Mark the wall where you want to insert the
provided anchors and screws, which must
be 3.875 in (98.5 mm) apart, and insert the
anchors and screws.
Leave about ¼ inch (6 mm) of each screw
protruded from the wall so that you can
insert the screws into the holes on the
bottom of the access point.
2 screws and 2 anchors
for ceiling or wall mounting
Note: The package does not include a
power adapter. You power up the access
point by connecting it to a PoE+ switch.
However, if you do not want to use PoE,
you can order a power adapter.
3.875 in (98.5 mm)
1. Using the anchors and screws provided,
attach the bracket to the ceiling, with the
rectangular protruding part of the bracket
against the ceiling surface.
2. Hold the access point upside down with
the front of the access point facing the
bracket. Then, line up the guides in the
bottom of the access point with the bracket.
3. Slide the access point into the bracket until
it locks in place. The locking tab must be at
the front of the access point.
The bottom of the access point includes two
holes that let you mount the access point on
two screws inserted in a wall.
Note: To unlock the access point, push the
locking tab toward the ceiling and slide the
access point out of the bracket.
Locking tab
Sideview
WAX610 IG 1st Compliance Draft 24Apr2020