User's Manual

NETGEAR, INC.
350 East Plumeria Drive San Jose, CA 95134
6
3 Create data call connection
Please follow the steps below to create data call connection.
Step1: Insert SIM card into module.
Step2: Connect PC and module via USB cable. And run “adb shell” on PC side in advance.
Step3: Use putty to connect module.
Step4: Execute the following commands to setup APN and launch connection manager.
/ # wnc-tools at_cmd AT+CGDCONT=1,\"IP\",\"internet\",\"\",0,0
/ # wnc-tools at_cmd "at+cgdcont?"
/ # /etc/init.d/start_QCMAP_ConnectionManager_le start
/ # QCMAP_CLI