User's Manual

SAR Statement
The information in this section applies to NETGEAR wireless products that are intended to be operated close to
human body.
NETGEAR products that are intended to be operated close to the human body are tested for body-worn Specific
Absorption Rate (SAR) compliance. The SAR limit set by the FCC is 1.6 W/kg.
The FCC has established detailed SAR requirements and NETGEAR products meet these requirements.
NETGEAR products comply with ANSI/IEEE C95.1-1999 and are tested in accordance with the measurement
methods and procedures specified in OET Bulletin 65 Supplement C.
NETGEAR products that are installed in USB ports demonstrate SAR compliance using a typical laptop
computer with a USB port. Other applications, such as handheld computers or similar devices, have not
been verified and might not compliance with related RF exposure rule and such use is prohibited.
RF Exposure Information
NETGEAR products have been evaluated under FCC Bulletin OET 65C (01-01) and found to be compliant to the
requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4) addressing RF exposure from radio
frequency devices. NETGEAR products meet the applicable government requirements for exposure to radio
frequency waves. To see the test results reporting the highest SAR level measured for this device, visit
http://www.netgear.com/about/regulatory/declarations-conformity/
Radiation exposure: NETGEAR products comply with radiation exposure limits set forth for an uncontrolled
environment and meet radio frequency (RF) exposure guidelines for wireless routers. NETGEAR products should be
installed and operated keeping the product 20cm or more away from a person’s body. For devices that are battery
powered and may be operated closer than 20cm to you, refer to the NETGEAR website for exposure levels.
NETGEAR USB dongle transmitters are approved for use in typical laptop computers. To comply with FCC RF
exposure requirements, do not use NETGEAR USB dongle transmitters in other devices or certain laptop and tablet
computer configurations where the USB connectors on the host computer are unable to provide or ensure the
necessary operating configurations intended for the device and its users or bystanders to satisfy RF exposure
compliance requirements.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
NETGEAR products comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
NETGEAR products may not cause harmful interference, and (2) NETGEAR products must accept any interference
received, including interference that may cause undesired operation.
For products available in the USA market, only channel 1~11 can be operated. Selection of other channels is not
possible.
The following statement applies to these products:
x D2200D
This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA.
On the product label of this equipment is a label that contains, among other information, a product identified in the
format US:WXXXXYYYZZZZZ. If requested, this number must be provided to the telephone company.
The following statement applies to these products:
● D7000