User's Manual

Table 1. Front panel LED and button descriptions
LED Description
WPS button
and LED
WPS button. Pressing this button initiates a WPS wireless connection procedure.
WPS LED
• Solid green. Wireless security is enabled.
• Blinking green.
The WiFi bridge/extender is attempting to use WPS to add a wireless
device or computer to the wireless network.
• Blinking green rapidly for about five seconds. WPS has failed to add a wireless device
or computer
.
• Blinking green rapidly and continuously. The
WiFi
bridge/extender is stuck in the
temporary AP setup locked state. For more information, see WPS Button Blinks Amber on
page 53.
• Off. No WPS connection exists.
WiFi On/Off
button
Pressing this button turns the wireless radios in the WiFi bridge/extender on or off.
5 GHz WiFi
5 GHz
• Solid blue. The 5 GHz wireless radio is operating.
• Off. The 5
GHz wireless radio is off.
2.4 GHz WiFi
• Solid green. The 2.4 GHz wireless radio is operating.
• Off. The 2.4
GHz wireless radio is off.
LAN
• Solid green. The LAN port has detected a 100 Mbps link with an attached device.
• Solid amber. The LAN port has detected a 10 Mbps link with an attached device.
• Off
. The LAN port has not detected a link with an attached device.
Online
• Solid amber. The IP address was not acquired.
• Solid green. The WiFi bridge/extender received an IP address and is ready to transmit
data.
• Off
. No Ethernet cable is connected between the WiFi bridge/extender and the other MoCA
device.
Power
• Solid amber. The WiFi bridge/extender is starting up after being powered on.
• Solid green. The power is on, and the WiFi bridge/extender is ready
.
• Blinking amber. A firmware
update is in progress.
• Blinking green. The firmware
is corrupt.
• Off. Power is not supplied to the WiFi bridge/extender.
Hardware Setup
8
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP