User's Manual

Supplemental Information
57
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
Factory Settings
You can return the WiFi bridge/extender to its factory settings. Use the end of a paper clip or
some other similar object to press and hold the Reset button on the back panel of the WiFi
bridge/extender for at least seven seconds. The WiFi bridge/extender resets, and returns to
the factory settings that are shown in the following table.
Table 4. WM2500RP WiFi bridge/extender factory default settings
Feature Default Behavior
Router login User login URL www.routerlogin.com or www.routerlogin.net
User name (case-sensitive) admin
Login password (case-sensitive) password
Local area
network (LAN)
LAN IP 192.168.1.250
Subnet mask 255.255.255.0
DHCP server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Wireless Wireless communication Enabled
SSID name
Network key (password)
Broadcast SSID Enabled
Transmission speed Auto
Country/region United States in the US; otherwise, varies by region
RF channel Auto
Operating mode Up to 300 Mbps
20/40 MHz coexistence Enabled
Data rate Best
Output power Full
Preset. For information, see the WiFi bridge/extender
label. (For a description of the WiFi bridge/extender label,
see Label on page 10.)
Note: Maximum wireless signal rate derived from IEEE
Standard 802.11 specifications. Actual throughput varies.
Network conditions and environmental factors, including
volume of network traffic, building materials and
construction, and network overhead lower actual data
throughput rate.