User's Manual
Table Of Contents
- MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
- Contents
- 1. Hardware Setup
- 2. Get Started with NETGEAR genie
- 3. Connections Setup
- 4. Maintenance
- 5. Advanced Settings
- 6. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
Advanced Settings
47
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
CAUTION: When you clear this check box and you add a new wireless client
through WPS, the WiFi bridge/extender’s wireless settings change to
an automatically generated SSID and passphrase. (The passphrase
is also referred to as the wireless network password or network key).
7. Click the Apply button.
Set Up a Wireless Card Access List
By default, any wireless device that is configured with the correct SSID can access your
wireless network. For increased security, you can restrict access to the wireless network to
allow only specific devices based on their MAC addresses.
For information about how to view the devices that are attached to your wireless network, see
View Network Devices on page 36.
To set up access control:
1. Log in to the WiFi bridge/extender.
For more information, see Use NETGEAR genie after Installation on page 16.
2. Select Advanced > W
ireless Settings
.
Scroll
down