User's Manual

Advanced Settings
43
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
4. To increase the wireless speed to the maximum supported speed, clear the Enable
20/40 MHz Coexistence check box.
This setting applies only to the 2.4 GHz band.
By default, 20/40 MHz coexistence is enabled to prevent interference between wireless
networks in your environment at the expense of the wireless speed. If no other wireless
networks exist in your environment, you can clear the Enable 20/40 MHz Coexistence
check box.
5. T
o enable WiFi multimedia, select the Enable WMM (Wi-Fi multimedia) settings check
box.
IMPORTANT:
The Fragmentation Length, CTS/RTS Threshold, and Preamble
Mode options are reserved for wireless testing and advanced
configuration only. Do not change these settings.
6. From the T
ransmit Power Control list, select the transmit power that you want.
7. Set up a wireless schedule.
For more information, see Set Up a Wireless Schedule on page 43.
8. Set up the WPS settings.
For more information, see Set Up the WPS Settings on page 45.
9. Set up a wireless card control list.
For more information, see Set Up a Wireless Card Access List on page 47.
10. Click the Apply button.
Set Up a Wireless Schedule
You can use this feature to turn off the wireless signal from your WiFi bridge/extender at
times when you do not need a wireless connection. For example, you could turn it off for the
weekend if you leave town.
 To configure and enable the wireless schedule:
1. Log in to the WiFi bridge/extender.
For more information, see Use NETGEAR genie after Installation on page 16.