User's Manual
Table Of Contents
- MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
- Contents
- 1. Hardware Setup
- 2. Get Started with NETGEAR genie
- 3. Connections Setup
- 4. Maintenance
- 5. Advanced Settings
- 6. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
Hardware Setup
12
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP
To cable your WiFi bridge/extender:
1. Install a MoCA-capable signal splitter between the coaxial port and your existing TV (1).
1
2
3
4
5
7
6
MoCA gateway
MoCA WiFi
bridge/extender
You can skip this step if you do not have a TV or other device connected to the coaxial
port.
2. Use a coaxial cable (2) to connect the WiFi bridge/extender to the MoCA-capable signal
splitter or your coaxial port.
3. Use the Ethernet cable (3) to connect your computer to the WiFi bridge/extender.
4. Connect the power adapter (4).
5. Power on your WiFi bridge/extender (5).
The WiFi bridge/extender
takes a couple of minutes to join your network.
6. After the WiFi bridge/extender
joins your network, the following LEDs are lit: