User's Manual

Canadian Department of Communications Radio Interference
Regulations
The information in this section applies to products bearing the statements:.
“This digital apparatus does not exceed the Class B limits for radio-noise emissions from digital apparatus
as set out in the Radio Interference Regulations of the Canadian Department of Communications.”
“Cet appareil numérique ne dépasse pas les limites de la classe B pour les émissions radio bruit des
appareils numériques, tel qu'énoncé dans le Règlement sur le brouillage radioélectrique du ministère des
Communications du Canada.”
CAN ICES-3 (B)/NMB-3(B)
CAN ICES-3 (A)/NMB-3(A)
Industry Canada
NETGEAR products comply with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) NETGEAR products may not cause harmful interference, and (2) NETGEAR products
must accept any interference received, including interference that may cause undesired operation.
 A6210
 JR6150
 WN3000RPv3
 VMB3000
 D6000
 JWNR2000v5
 WN370
 VMC3010
 D6010
 JWNR2010v5
 WNDR3400v3
 VMC3030
 D3600
 R6050
 WNR1000v4
 D3610
 R6220
 WNR2010
 EX2700
 R7500
 WNR2020
 HMNC100
 R8000
 WNR614
 JNR1010v2
 WAC120
 WNR618
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement
 A6210
 JR6150
 WN3000RPv3
 VMB3000
 D6000
 JWNR2000v5
 WN370
 VMC3010
 D6010
 JWNR2010v5
 WNDR3400v3
 VMC3030
 D3600
 R6050
 WNR1000v4
 D3610
 R6220
 WNR2010
 EX2700
 R7500
 WNR2020
 HMNC100
 R8000
 WNR614
 JNR1010v2
 WAC120
 WNR618
The following statements apply to this product:
 R7500
 VMB3000
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.