User's Manual

Radiation exposure: NETGEAR products comply with radiation exposure limits set forth for an uncontrolled
environment and meet radio frequency (RF) exposure guidelines for wireless routers. NETGEAR products should be
installed and operated keeping the product 20cm or more away from a person’s body. For devices that are battery
powered and may be operated closer than 20cm to you, refer to the NETGEAR website for exposure levels.
NETGEAR USB dongle transmitters are approved for use in typical laptop computers. To comply with FCC RF
exposure requirements, do not use NETGEAR USB dongle transmitters in other devices or certain laptop and tablet
computer configurations where the USB connectors on the host computer are unable to provide or ensure the
necessary operating configurations intended for the device and its users or bystanders to satisfy RF exposure
compliance requirements.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
NETGEAR products comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
NETGEAR products may not cause harmful interference, and (2) NETGEAR products must accept any interference
received, including interference that may cause undesired operation.
For products available in the USA market, only channel 1~11 can be operated. Selection of other channels is not
possible.
The following statement applies to these products:
 A6210
 JWNR2010v5
 WN3000RPv2
 C6300
 R6050
 WN3500RP
 D6200V2
 R7500
 WNDR3400v3
 EX6100
 R8000
 WNR2010
 EX6200
 VEGN2200
 WNR2020
 HMNC100
 WAC120
 WNR614
 JR6150
 WN370
 WNR618
 JWNR2000v5
 WN2500RP
 EX2700
The device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
The following statement applies to these products:
 A6210
 R6050
 C6300
 R7500
 C6300XB3
 R8000
 D6200V2
 STS7000
 EX6100
 WN2500RP
 EX6200
 WNDR3400v3
 HMNC100
 JR6150
The device operates in 5.15~5.25GHz frequency range. It is restricted in indoor environment only.
The following statements apply to this product:
 WAC120
The device operates in 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range. It is restricted in indoor environment only.
The band from 5600-5650MHz will be disabled by the software during the manufacturing and cannot be changed by
the end user. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.