User's Manual
Table Of Contents
- N300 Wireless Router
- Contents
- 1. Hardware Setup
- 2. Connect to the Network and Access the Router
- 3. Specify Initial Settings
- 4. Optimize Performance
- 5. Control Access to the Internet
- 6. Specify Network Settings
- Set Up a Default DMZ Server
- Change the Router’s Device Name
- Change the LAN TCP/IP Settings
- Specify the IP Addresses That the Router Assigns
- Reserve LAN IP Addresses
- Use the WPS Wizard for WiFi Connections
- Specify Basic WiFi Settings
- Set Up a WiFi Guest Network
- Control the Wireless Radio
- Set Up a WiFi Schedule
- Specify WPS Settings
- Dynamic DNS
- 7. Manage Your Network
- 8. Specify Internet Port Settings
- 9. Troubleshooting
- A. Supplemental Information
Supplemental Information
107
N300 Wireless Router
Local area
network (LAN)
LAN IP 192.168.1.1
Subnet mask 255.255.255.0
DHCP server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Time zone United States is Pacific Time; otherwise, varies by region
Time zone adjusted for daylight
saving time
Disabled
Wireless Wireless communication Enabled
SSID name
Preset. For information, see the product label.
Network key (password)
Broadcast SSID Enabled
Transmission speed Auto
Note: Maximum wireless signal rate derived from IEEE
Standard 802.11 specifications. Actual throughput varies.
Network conditions and environmental factors, including
volume of network traffic, building materials and
construction, and network overhead lower actual data
throughput rate.
Country/region United States in the US; otherwise, varies by region
RF channel Auto
Operating mode Up to 300 Mbps
20/40 MHz coexistence Enabled
Data rate Best
Output power Full
Table 3. Router factory default settings (continued)
Feature Default Behavior
DRAFT