User's Manual
Table Of Contents
- WN3000RPv2 WiFi Range Extender
- Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In to the Extender After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use the Smart Setup to Connect the Extender to a Network
- Use the WPS Wizard for WiFi Connections
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- Manage Profiles
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- A. Supplemental Information
FAQs and Troubleshooting
38
WN3000RPv2 WiFi Range Extender
passphrase or key. The passphrase or key is case-sensitive. For example,
PASSWORD25 is not the same as Password25 or password25.
• If the extendercannot detect your WiFi network, check to see if your WiFi network is still
up. Make sure that the wireless router is turned on. If possible, move the extender closer
to the wireless router.
• If the extender Link Rate LED is red, a poor wireless connection exists between the
wireless router and the extender. You can establish the best connection with a clear line
of sight between the extender and the wireless router. Make sure that no physical
obstacles exist between the extender and the wireless router, and try to move the
extender closer to the wireless router.
If you use the Setup Wizard, and the extender cannot connect to the wireless router or
cannot get an IP address from the wireless router, or the wireless router is not connected to
the Internet, the Setup Wizard displays the following message:
You are not able to connect to the Internet. Click Continue to run through setup again to
connect to your network.
Either run the Setup Wizard again or exit the Setup Wizard and try again later (see and ).