User's Manual

FAQs and Troubleshooting
37
WN3000RPv2 WiFi Range Extender
7. Question. I have enabled a wireless MAC filter (wireless access control or ACL) on my
wireless i router. What should I do when installing the extender?
Answer. When the wireless device connects through the extender to your router, the
MAC address of the wireless device shown on the router is translated to another MAC
address. If your router's MAC filter is enabled, the wireless device connects to the
extender but cannot get an IP address from the extender and cannot access the Internet.
To allow the wireless device to receive an IP address from the extender and access the
Internet, you must provide the translated MAC address to the router.
 To get the translated MAC address:
1. Disable the MAC filter on your router.
2. Turn on the extender and connect all of your wireless devices to the extender.
3. Make sure that the Link Rate LED remains lit.
4. Log in to the router and check the attached devices on the Attached Devices or similar
screen.
5. Add any MAC addresses that begin with 02:0F:B5 to your router’s MAC filter table.
Cannot Log In to the Extender
If you have trouble connecting to the extender, try to locate the source of the problem:
• Make sure that you use the correct user name and password to log in:
- User name. admin
- Password. password
• If your browser displays an error page, make sure that you include http:// when you type
http://www.mywifiext.net in the address field of your Internet browser. If you leave it out,
you might not be able to connect.
• If you already set up the extender but can no longer connect to it wirelessly, check if the
Link Rate LED is off or red.
• If you cannot connect to the extender from your computer with WiFi, you can use an
Ethernet cable to connect your computer to the Ethernet port on the extender. For more
information, see
Cable a Computer or Device to the Ethernet Port on page 14.
Cannot Join the Extender WiFi Network
To join a WiFi network, you must know its network name (also called the SSID) so that you
can select it. If the network is secure, you must know the passphrase or key. If the extender
does not connect to the network that you select, the following message displays:
Connection was not established to the selected network.
If this situation occurs, the cause might be one of the following:
• You might have typed the network name, passphrase, or key incorrectly. Use the Setup
Wizard to select a WiFi network from the list with detected networks, and retype the