User's Manual
Table Of Contents
- WN3000RPv2 WiFi Range Extender
- Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In to the Extender After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use the Smart Setup to Connect the Extender to a Network
- Use the WPS Wizard for WiFi Connections
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- Manage Profiles
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- A. Supplemental Information
Manage the Extender Network and Settings
17
WN3000RPv2 WiFi Range Extender
Log In to the Extender After Initial Setup
After installation, you can log in to the extender to view or change its settings.
To log in to the extender after the initial setup:
1. Connect a computer or mobile device to the extender
’s network.
2. Launch a web browser and enter www
.mywifiext.net in the address field.
A login screen displays.
3. Enter admin for the user name and password for the password.
If your extender has an Internet connection, the extender automatically checks for new
firmware at the NETGEAR website.
The Status screen displays.
Change the admin Password
The user name to access the extender is admin, and its default password is password.
NETGEAR strongly recommends that you set a more secure password.
To change the password for the extender:
1. On your computer
, launch a web browser.
2. In the address field of your browser
, enter http://www.mywifiext.net.
You are prompted to enter a user name and password. If you do not see the login prompt,
make sure to include http:// when you type http://www
.mywifiext.net in your browser.
3. Type admin for the user name and password for the password.