User's Manual
Table Of Contents
- N450 Wireless Router WNR2500
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. genie Basic Settings
- 4. genie Advanced Home
- 5. Security
- 6. Administration
- 7. Advanced Settings
- 8. Monitoring
- 9. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
Advanced Settings
84
N450 Wireless Router WNR2500
The Wireless Access Point screen displays:
2. Select the Enable Access Point Mode check box.
The screen adjusts.
3. Configure the IP address settings for the router:
• Get dynamically from existing router. By default, the Get dynamically from existing
router radio button is selected, enabling the router to receive its IP address and other
IP settings from the other router or gateway in your network.
• Use fixed IP Address. Select the Use fixed IP
Address radio button to set up static IP
address settings.
NETGEAR does not recommend this setting.
Note: If the other router or gateway in your network also has wireless
capability, NETGEAR recommends that you use wireless settings on
your router that are different from those on the other router or
gateway to avoid interference. You could also disable the wireless
radio on the other router or gateway and use your router only for
wireless client access.
4. Click the Apply button.