User's Manual
Table Of Contents
- N450 Wireless Router WNR2500
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. genie Basic Settings
- 4. genie Advanced Home
- 5. Security
- 6. Administration
- 7. Advanced Settings
- 8. Monitoring
- 9. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
Advanced Settings
109
N450 Wireless Router WNR2500
4. (Optional) Select the Use This Interface ID check box, and specify the interface ID that you
want to be used for the IPv6 address of the router’ s LAN interface.
If you do not specify an ID here, the router generates one automatically from its MAC
address.
5. Specify IPv6 filtering.
When the connection type is not IPv6 Pass Through or Disabled, the router starts the
stateful packet inspection (SPI) firewall function on the WAN interface. The router creates
connection records and checks every inbound IPv6 packet. If the inbound packet is not
destined to the router itself and the router does not expect to receive such a packet, or
the packet is not in the connection record, the router blocks this packet.
This function has
two modes.
Specify the mode by selecting one of the following radio buttons:
• Secured. In the secured mode, which is the default mode, the router inspects both
TCP and UDP packets.
• Open. In the open mode, the router inspects UDP packets only.
6. Click the Apply button.
IPv6 Auto Config
To set up an IPv6 Internet connection through auto configuration:
1. Select Advanced > Advanced Setup > IPv6.
The IPv6 screen displays.
2. Select Auto Config from the menu.
The screen adjusts: