User's Manual
Table Of Contents
- N450 Wireless Router WNR2500
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. genie Basic Settings
- 4. genie Advanced Home
- 5. Security
- 6. Administration
- 7. Advanced Settings
- 8. Monitoring
- 9. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
Hardware Setup
10
N450 Wireless Router WNR2500
Wireless
• Solid blue. The wireless radio is operating.
• Off. The wireless radio
is off.
LAN ports
1–4
• Solid green. The LAN port has detected a 100 Mbps link with an attached device.
• Solid amber. The LAN port has detected a 10 Mbps link with an attached device.
• Off. No link is detected on the LAN port.
WPS
• Solid green. Indicates that wireless security is enabled.
• Blinking green. The router is attempting to use WPS to add a wireless device or computer to
the wireless network.
• Blinking green rapidly for about 5 seconds. WPS has failed to add a wireless device or
computer
.
• Blinking green rapidly and continuously.
The router is in stuck in the temporary AP setup
locked state. For more information, see The WPS (Push 'N' Connect) Button Blinks
Amber on
page 129.
• Off. No WPS connection exists.
WiFi On/Off
button
Turns the wireless radio in the router on or off.
WPS button Initiates a WPS wireless connection procedure.
Table 1. Front panel LED descriptions (continued)
LED Description