User Manual
Table Of Contents
- R6100 WiFi Router
- Contents
- 1. Hardware Setup
- 2. Getting Started
- 3. Basic Settings
- 4. Advanced Home Settings
- 5. USB Storage
- 6. Security
- Keyword Blocking of HTTP Traffic
- Block Services (Port Filtering)
- Port Triggering to Open Incoming Ports
- Port Forwarding to Permit External Host Communications
- How Port Forwarding Differs from Port Triggering
- Set Up Port Forwarding to Local Servers
- Set Up Port Triggering
- Schedule Blocking
- Security Event Email Notifications
- 7. Administration
- 8. Advanced Settings
- 9. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
Advanced Settings
85
R6100 WiFi Router
Wireless Access Point
You can set up the router to run as an access point (AP) on the same local network as
another router.
To set up the router as an AP:
1. Use an Ethernet cable to connect the Internet port of this router to a LAN port in the
other router
.
Cable this port to a LAN port
on the other router
2. Select ADVANCED > Advanced Setup > Wireless AP.
3. Select the Enable Access
Point Mode check box.
4. Scroll down and select the check box for the IP address setting that you want to use:
• Get dynamically from existing router.
The other router on the network assigns an
IP address to this router while this router is in AP mode.
• Use fixed IP address (not recommended). Use this setting if you want to manually
assign a specific IP address to this router while it is in
AP mode. Using this option
effectively requires advanced network experience.