User's Manual
Table Of Contents
- R6200v2 Smart WiFi Router
- Contents
- 1. Hardware Setup
- 2. Getting Started
- 3. NETGEAR genie Basic Settings
- 4. NETGEAR genie Advanced Home
- 5. USB Storage
- 6. ReadySHARE Printer
- 7. Security
- 8. Administration
- 9. Advanced Settings
- 10. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
Advanced Settings
95
R6200v2 Smart WiFi Router
The AP Mode section of the screen expands.
4. Select the check box for the IP address setting that you want to use:
• Get an IP address dynamically from the other router.
The other router on the
network assigns an IP address to this router while this router is in AP mode.
• Fixed IP address (not recommended). Use this setting if you want to manually
assign a specific IP address to this router while it is in
AP mode. Using this option
effectively requires advanced network experience.
Note: To avoid interference with other routers or gateways in your network,
NETGEAR recommends that you use different wireless settings on the router
in access point mode.You could also turn off the wireless radio on the other
router or gateway and use your router only for wireless client access.
5. Click the Apply button.
The IP address of the router changes, and you are disconnected. To reconnect, close and
restart your web browser
, and type http://www.routerlogin.net.