User's Manual
Table Of Contents
- R6200v2 Smart WiFi Router
- Contents
- 1. Hardware Setup
- 2. Getting Started
- 3. NETGEAR genie Basic Settings
- 4. NETGEAR genie Advanced Home
- 5. USB Storage
- 6. ReadySHARE Printer
- 7. Security
- 8. Administration
- 9. Advanced Settings
- 10. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
ReadySHARE Printer
61
R6200v2 Smart WiFi Router
3. Select the language and click OK.
The setup file installs the utility.
4. On each computer on your network that shares the USB printer
, perform the initial setup of
the NETGEAR USB Control Center.
The first time you use the USB printer that is connected to your router, you are asked to
select the USB printer
. For more information, see Initial Setup of the NETGEAR USB
Control Center on page 75.
5. (Optional) Change the default settings.
For more information, see Configure the NETGEAR USB Control Center on page 77.
Set Up the NETGEAR USB Control Center
The first time you access the utility, you are asked to select the printer.
• When a USB printer is detected and connected automatically during the initial setup, you
have to disconnect the printer and wait for the prompt asking you to click Connect.
• Y
ou might be asked to install the driver for this printer. After the driver is installed, the
printer status changes to Available.
To set up the NETGEAR USB Control Center:
1. On each computer on your network that shares the USB printer
, launch the NETGEAR
USB Control Center the same way you launch any application program on your
Windows or MAC computer.