User's Manual
Table Of Contents
- N300 Wireless Router with External Antennas WNR1500
- Contents
- 1. Hardware Setup
- 2. Router Internet Setup
- 3. Wireless Settings
- 4. Content Filtering
- Live Parental Controls
- Keyword Blocking of HTTP Traffic
- Block Outbound Traffic to Internet Services
- Set the Time Zone
- Schedule Blocking
- Enable Security Event Email Notification
- View Logs of Web Access or Attempted Web Access
- Allow Inbound Connections to Your Network
- Port Forwarding to a Local Server
- Port Triggering
- 5. Network Maintenance
- 6. Advanced Settings
- 7. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
12 | Chapter 1. Hardware Setup
NETGEAR N300 Wireless Router with External Antennas WNR1500 User Manual
4. Locate the cable (A) that is still attached to your computer. Insert that cable into a yellow
LAN port on the router, as shown in the following figure:
A
Figure 6. Connect the Ethernet cable to a LAN port on the router
5. Connect any additional wired PCs to your router by inserting an Ethernet cable from a PC
into one of the three remaining LAN ports.
6. Start your network in the correct sequence, as described below.
CAUTION:
Failure to start or restart your network in the correct sequence could
prevent you from accessing the Internet.
To start your network:
1.
Plug in and turn on the cable or DSL modem. Wait 2 minutes.