User's Manual

Table Of Contents

Notification of Compliance

Powerline 500 WiFi Access Point (XWN5001)

The voltage and current rating of the cable should be greater than the ratings marked on

the product.

• To help prevent electric shock, plug the system and peripheral power cables into properly

grounded electrical outlets.

• Do not use adapter plugs. If you must use an extension cable, use a three-wire cable with

properly grounded plugs.

• Observe extension cable and power strip ratings. Make sure that the total ampere rating

of all products plugged into the extension cable or power strip does not exceed 80

percent of the ampere ratings limit for the extension cable or power strip.

• To help protect your system from sudden, transient increases and decreases in electrical

power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).

• Position system cables and power cables carefully; route cables so that they cannot be

stepped on or tripped over. Be sure that nothing rests on any cables.

• Do not modify power cables or plugs.

• Always follow your local and national wiring rules.

Regulatory Compliance Information

FCC Statement

Federal Communication Commission Interference Statement

This equipment has been tested and complies with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used according to the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which is found by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experience radio/TV technician for help.

FCC Caution: Any changes or modification not expressly approved by the party responsible

for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and