User's Manual
Table Of Contents
- N750 Wireless Dual Band Gigabit Router WNDR4300
- Contents
- 1. Hardware Setup
- 2. Set Up Your Internet Connection
- 3. Wireless Settings
- 4. Content Filtering Settings
- 5. Network Maintenance
- 6. USB Storage
- 7. Advanced Settings
- 8. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
Chapter 1. Hardware Setup | 13
N750 Wireless Dual Band Gigabit Router WNDR4300 User Manual
6. Locate the cable you removed from the modem in step 2. Securely insert that cable (4) into
a LAN port on the router such as LAN port 1.
4
7. Your network cables are connected, and you are ready to start your network. It is important
that you start your network in the correct sequence (first power on the modem, and after it
finishes starting up, power on the router).
Verify the Cabling
Verify that your router is cabled correctly by checking the router LEDs. Turn on the router by
pressing the On/Off button on the back.
• The Power LED is green when the router is turned on.
•
The LAN ports are green for each PC cabled to the router by an Ethernet cable.
•
The 2.4 GHz N/G-Band LED is on, and the 5.0 GHz N-Band LED is on.
•
The Internet LED is on. If it is not, make sure that the Ethernet cable is securely
attached to the router Internet port and the modem, and that the modem is powered on.
Verify that the LAN LEDs (1 through 4) are lit for any computers cabled to the router by
an Ethernet cable.