User Manual
Table Of Contents
- N600 Wireless Dual Band Gigabit Router WNDR3700v4
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. NETGEAR genie Basic Settings
- 4. NETGEAR genie Advanced Home
- 5. Storage
- 6. Security
- 7. Administration
- 8. Advanced Settings
- 9. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
Advanced Settings
90
N600 Wireless Dual Band Gigabit Router WNDR3700v4
To set up a static route:
1. Select Advanced > Advanced Setup > Static Routes, and click Add to display the
following screen:
2. In the Route Name field, type a name for this static route (for identification purposes only.)
3. Select the Privat
e check box if you want to limit access to the LAN only. If Private is
selected, the static route is not reported in RIP.
4. Select the Active check box to make this route ef
fective.
5. Type the IP address of the final destination.
6.
Type the IP subnet mask for this destination. If the destination is a single host, type
255
.255.255.255.
7. T
ype the gateway IP address, which has to be a router on the same LAN segment as the
ro
uter.
8. Type a number from 1 through 15 as the metric value.
T
his value represents the number of routers between your network and the destination.
Usually, a
setting of 2 or 3 works, but if this is a direct connection, set it to 1.
9. Click Apply to
ad
d the static route.