User's Manual

Connecting to the Internet

Mobile Voice HSPA+ Broadband 11n Wireless Router MVBR1210C

Internet Service Provider Select your Internet Service Provider from the drop-down list.

Access Number The remote site's phone number.

PIN code Pin code of the SIM card, where applicable.

APN Access point name.

PDP type Select the type of packet data protocol:

• IP

• PDP-IP

• PPP

• PPP-IP

Connect automatically at startup When this check box is selected, the modem automatically connects

to the network when powered up. This should be selected after login

information is provided.

Roaming automatically When this check box is checked, the unit might roam to any available

operator in range and might incur roaming charges.

Use internal antenna If this check box is selected, the router will use the internal antenna

rather than the external antenna.

Wireless Button Configuration Select the option to determine the behavior of the WPS push button

on the front panel when pressed.

• Control Wi-Fi Only: Pressing the push button toggles the WiFi

function. If WiFi is turned on, pressing the push button turns off the

WiFi. Pressing it again will turn on the WiFi. This function is

available only if the WiFi function is enabled. The Wireless

Broadband function is unaffected.

• Control Both Wi-Fi and Wireless Broadband: Pressing the push

button toggles both the WiFi function and wireless broadband at

the same time. If WiFi is turned on, pressing the push button turns

off the WiFi. At the same time, the wireless broadband connection

is disconnected. If you press the push button again, WiFi is turned

on and the router attempts to re-establish the wireless broadband

connection. Depending on the coverage, wireless broadband

coverage might or might not be connected successfully.

Connection status Current WAN port status.

Table 3. Settings

Fields and Check Boxes Description