User's Manual

NETGEAR JDGN1000 User Manual
69
Note:
You can use a single port number, several port numbers separated by commas,
port blocks consisting of two port numbers separated by a dash, or any
combination of these, for example 80, 90-140, 180.
5.6.4 WAN Setup
Choose Advanced > WAN Setup and the following page appears.
Figure 95 WAN setup
In this page, you can set up a Default DMZ Server and allow the router to respond
to a 'ping' from the internet. Both of these options have security issues, so use
them carefully.
Default DMZ Server
Specifying a Default DMZ Server allows you to set up a computer or server that is
available to anyone on the Internet for services that you haven't defined. There are
security issues with doing this, so only do this if you're willing to risk open access. If
you do not assign a Default DMZ Server, the router discards any incoming service
requests which are undefined.
To assign a computer or server to be a DMZ server:
1. Click the Default DMZ Server check box.
2. Type the IP address for that server.
3. Click Apply.
Note:
The router must enabled the NAT. Otherwise, DMZ do not enable.