User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Advanced Configuration
99
ProSafe Dual Band Wireless-N Access Point WNDAP360
To configure the wireless access point to repeat the wireless signal:
1. Select the 802.11b/bg/ng or 802.11a/na tab.
2. Configure the security profiles on the wireless access point (AP2 in the previous figure):
a. Select Configuration >
Wireless Bridge. The Bridging screen displays (see the
following figure).
b. Select the Ena
ble Wireless Bridging check box. The Local MAC Address field is a
nonconfigurable field that shows the MAC address of the wireless access point.
c. Select the W
ireless Point-to-Multi-Point Bridge radio button. The screen adjusts.
Figure 60.
d. The profile table shows four security profiles. Choose a security profile to edit by
selecting the corresponding radio button to the left of the profile.
e. Click Edit to configure
the selected security profile settings. The Edit Security Profile
screen displays for the selected security profile. (The following figure contains some
examples.)