User's Manual
Table Of Contents
- ProSafe Dual Band Wireless-N Access Point WNDAP360
- Contents
- 1. Introduction
- 2. Installation and Basic Configuration
- 3. Wireless Configuration and Security
- 4. Management
- 5. Advanced Configuration
- 6. Troubleshooting
- Basic Functioning
- You Cannot Access the Internet or the LAN from a Wireless-Capable Computer
- You Cannot Configure the Wireless Access Point from a Browser
- When You Enter a URL or IP Address a Time-Out Error Occurs
- Troubleshooting a TCP/IP Network Using the Ping Utility
- Problems with Date and Time
- Use the Packet Capture Tool
- A. Supplemental Information
- B. Command-Line Reference
- C. Notification of Compliance
- Index
Advanced Configuration
94
ProSafe Dual Band Wireless-N Access Point WNDAP360
Figure 56.
To configure a point-to-multipoint wireless network:
1. Select the 802.1
1b/bg/ng or 802.11a/na tab.
2. Configure the security profiles on the wireless access point (AP1 on LAN Segment 1 in the
previous figure
):
a. Select Configuration > W
ireless Bridge. The Bridging screen displays. (The
following figure shows the screen after you have completed step c.)
Figure 57.
Wireless PC card
in a notebook computer
Point-to-point
bridge mode
Multipoint
bridge mode
Point-to-point
bridge mode
Router
Hub or switch
Hub or switch